EMBROIDERY BOBBIN CASE 6 EACH for TAJIMA,BARUDAN,BROTHER (USES L BOBBINS)
Our Embroidery Machine Friends have asked us for a SIX PACK SET of EMBROIDERY MACHINE Small PIGTAIL BOBBIN CASES .
This is a Set of 6 Brand New ANTI-SPIN (NO BACK LASH) Bobbin Cases that fit theBarudan,Tajima,Brother,Meistergram,
Toyota,Ricoma,Yamata,Melco,SWF,Happy and any other imported embroidery machine, uses L bobbins
These "L" size bobbin cases use bobbins that are 7/8" Diameter.
METRIC MEASUREMENT: The Bobbins that fit these Bobbin Cases Measure: 21.0MM WIDE & 8.5MM THICK
These Bobbin Cases have deep cut large needle slots to allow for needle flexing and prevent your needles from contacting the Bobbin Cases.
These are the Highest Quality NO BACK LASH Bobbin Cases.
What is NO BACK LASH?
A special anti-spin spring is built into the bobbin case assembly to prevent the bobbin from spinning when the machine is suddenly stopped. If the bobbin spins when the machine stops, there is a good chance that a single loop of thread will fall out of the bobbin case. This condition will cause the thread to snap as soon as the machine begins to sew.
If you are running several or many of these machines, now is the time to stock up. Because these machines are run continuously the Bobbin Cases tend to wear out quickly, often in just 6 months. Are you have problems producing a "Balanced" stitch with no thread knots on the top or bottom of the material? This condition is usually caused by a poorly functioning Bobbin Case.